iCES ICR-240 Bedienungsanleitung Seite 5

OFF / NAP" button (2) to turn radio on or off.
1. For setting alarm time 1 with buzzer, press "ALARM 1 / VOL –" button (4) and
indicator (E) will flash. For setting alarm time 1 with radio, press "ALARM 1 /
VOL –" button (4) twice and
2. When the digits are flashing, press "HOUR / TUNING –" button (5) repeatedly to
change the hour setting. Press "MIN / TUNING +" button (9) repeatedly to change
the minute setting.
3. Press "ALARM 1 / VOL –" button (4) to confirm.
4. To cancel alarm, press "ALARM 1 / VOL –" button (4) three times when the
current time is showing. The alarm indicators will be off.
5. When the alarm sounds, press any button to turn off alarm or press "SNOOZE /
SLEEP / DIM" button (1) to enter snooze mode.
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut
the radio sound. If alarm waken up by radio, volume control for radio is not
available.
6. Follow the same instructions for alarm 2 with "ALARM 2 / VOL +" button (8).
Note:
 You must make the time and alarm time adjustments while the display is flashing.
The display will stop flashing after approximately 10 seconds if adjustments are
not made.
 If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2
set to radio alarm, when buzzer is activated by alarm1 and radio is activated by
alarm2, the previous alarm does not stop automatically and has both buzzer and
radio sound together.
RADIO
General Operations
1. Press the "ON/OFF/NAP" button (2) to turn radio on and off.
2. For manual tuning, press "HOUR / TUNING –" button (5) or "MIN / TUNING
+" button (9) for increments of 0.1mHz.
3. For automatic tuning, press and hold down "HOUR / TUNING –" button (5) or
"MIN / TUNING +" button (9) for approximately 3 seconds. Depress the button
and the radio will start to scan for the next available station.
4. Press "ALARM 1 / VOL –" button (4) or "ALARM 2 / VOL +"button (8) to adjust
indicator (F) will flash.
or will blink during