Setting Up The Dr 315 (Quick Guide); Wizard - Albrecht DR315 Bedienungsanleitung

7 Setting up the DR 315 (Quick Guide)

The first time you want to connect to the internet to listen to radio stations, you will have to
set up the connection. This is done with the Internet Wizard. The radio has been
configured to automatically run the Internet Wizard when you enter the Internet Radio
mode (If a connection has not already been made).
Alternatively you can run the Internet Wizard manually if you want to connect to a different
WiFi network. This can be accessed from the System Setup/Internet Setup menu in the
MAIN MENU.
The Internet Setup menu consists of 4 options:
Wizard, PC Settings, View Settings and Manual Settings.

7.1 Wizard:

1. Select the Wizard.
2. The Wizard will then automatically scan for available Wireless or Wired (Ethernet)
networks and a list is displayed.
3. Turn the TUNE knob to either select desired network (SSID) or select one of the
three other options. Rescan (Performs a rescan for networks), Wired (Optional)
(Will select Ethernet) or Manual Config (Will allow user to manually configure the
Wireless setup).
4. If the network has no security the following messages appears – "Please wait
Connecting", "Please wait Acquiring address" and "Connected"
the Internet Radio menu.
5. In the next step you can transfer your WLAN setup from your router automatically.
Your router has to support WPS for this. If this is not the case select "Skip WPS"
and continue with step 6. If your router supports this feature you can choose
between two methods: via push button control or via PIN. If you need help to setup
this feature on your router please have a look in your router´s manual.
6. If the network has a security feature enabled the DR 315 will prompt you to enter the
key or pass phrase. The security details must match the security information
configured in the wireless access point. The authentication type (WEP, Open, WPA
or WPA2) will automatically be detected.
7. Password Entry. To enter your passphrase use the TUNE knob to select the characters
and confirm them by pressing the knob. If you want to erase a character use the left
arrow or select the button BKSP (Backspace). When you are done entering the
passphrase or want to abort the process select OK or Cancel.
- 10 -
will be displayed on