Albrecht Tectalk Float Bedienungsanleitung Seite 28

This will prompt any receiving unit that your transmission has ended.
When the Roger Beep tone is enabled, the tone icon appears on the
LC Display.
Keypad Program Tone Setting
When a key is pressed, a beep tone is heard to confirm your
command. The user may enable or disable this keypad program tone.
When the Keypad tone is enabled, the tone icon appears on the LC
Display.
Stop Watch function
This function will enable a one hour timer function.
1. Press the MENU button eleven times, until the Stop Watch
icon and the 00:00 indication will blink on the LC Display.
2. Press the CH UP button to start counting and press the
CH DOWN button to stop the function. The radio can still
operate in this mode.
3. Press the CH UP button again to re-start.
4. To reset the timer press the CH DOWN button two times.
5. To exit to Stand-by mode press the LOCK button.
Keypad Lock
To avoid entering unwanted command, press and hold the
LOCK button for about 2 seconds. The Lock icon will appear on the LC
Display. When the keypad is locked, only the PTT, CALL and Monitor
buttons are enabled. To unlock the keypad press and hold the LOCK
button for about 2 seconds.
LCD Backlight
Shortly press the MONITOR button to backlight the LC Display. Press
this button again to turn OFF the LCD backlight.
Monitor Function
Press and hold the MONITOR button for about 4 seconds to activate
the Monitor function. Press MONITOR button once to return.
If require to listen to weak signal with background noise temporarily,
press and hold MONITOR button for about 2 seconds. You will hear
28 English