Installation - Albrecht Tectalk Float Bedienungsanleitung

Installation

1 Removing the belt clip
a. Pull the belt clip latch
away from the unit
b. While pulling the belt
clip latch, push up the
belt clip as shown in Figure 1
2 Installing the belt clip
a. Slide the belt clip into the
slot as shown in Figure 2
b. A "click" indicates the belt clip
Is locked into position
3 Installing the supplied Li-ion rechargeable battery
a. Unscrew the screw and then
remove the battery door.
b. Insert the battery connector into
the socket located inside the
battery compartment and install
the battery pack.
c. Re-install the battery door and
tighten the screw
4. Charging the rechargeable battery pack
It is recommended to turning OFF the unit while charging.
Charge the Battery pack 10-14 hrs. prior to initial use.
When the battery capacity is low, the bA Lo indication
and the battery status icon will flash on the LC
Display. Recharge the battery pack at this time,
please refer to the following item "BATTERY
CHARGING".
English
Figure1 Figure2
21