Clatronic DR 836 Bedienungsanleitung Seite 39

Setting the time and the alarm time
To be able to set the time, a watch battery must be inserted in the battery compartment.
NOTE:
The time display is a 12-hour analog display. "PM" will show in the display for afternoon.
1. Press the MODE button (6) once. The "AL" indicator will light up in the display. The
current set alarm time is shown.
2. Press the MODE button once more. The "AL" indicator will flash on the display. Now
keep the SET button (4) pressed until the desired alarm time has been set. Then
press the MODE button. The time display will appear.
3. Press the MODE button three times. Now keep the SET button pressed until the time
has been set. The seconds will automatically be reset to 12:01. Then press the MODE
button.
Listening to the Radio
1. Press the SCAN button (8) repeatedly to set a radio station.
2. When the end of the frequency band is reached the scanning process stops. If you
would like to start scanning again from the beginning of the frequency band, press the
RESET button (9).
3. The volume is set with the volume buttons (2).
4. An aerial is integrated into the device for the reception of stations. If reception is too
weak, try changing the position of the device in order to improve reception.
5. After use, turn the device off again by the ON/OFF button (1). The display shows the
time that has currently been set.
1. Press the MODE button (6) once. The "AL" indicator will light up in the display. The
currently set alarm time is shown.
2. Press the SET button (4). The symbols " " and "
alarm time is activated.
Once the set alarm time has been reached, a buzzer will be heard.
NOTE:
If the two AAA batteries are empty, a buzzer will not be heard.
Alarm function
" will show on the display. The
GB
39