Reloop IQ2+ Usb Bedienungsanleitung Seite 32

The following three crossfader effects are at your disposal:
a.) LoopX
b.) PitchX
c.) StutterX
NOTE!
Please take into consideration that when using the crossfader effects
PitchX -22, b- and StutterX -22, c-, the X parameter knob -25- and the beat
assignment buttons for the DSP effect unit -24- are not active.
(only available for Reloop IQ2+)
16. USB terminal (see designations, numbers 46 & 47)
NOTE!
Please also observe the enclosed quick installation guide for usage
with Traktor.
32
Depending on the bar that has been adjusted via the X parameter knob -25-
or the beat assignment buttons for the DSP effect unit -24- (as described in
the chapter "operation", point 14) a loop can be created with this effect. The
further the crossfader is being moved to the opposite side the lower the loop
sequence will become. Move the crossfader back to its original position in
order to deactivate the effect.
Move the crossfader to the opposite side in order to decrease the running
track's pitch. With this effect it is possible to simulate the sound of a record
that is continuously slowing down. Move the crossfader back to its original
position in order to deactivate the effect.
Move the crossfader to the opposite side in order to loop a sequence. The
further you move the crossfader to the opposite side the shorter the
sequence will become. Move the crossfader back to its original position in
order to deactivate the effect.
If you connect your computer via the USB ports -46/47- it will automatically
recognize them as external sound cards (USB codec = UAC3556B 1/2). No
special drivers are necessary. This function works as plug 'n' play with
current operating systems (Windows XP, Vista or Mac OS.X). Now it is
possible to play music files on your computer and to route them to the
Reloop IQ2+ USB via the USB ports 1 -46- (channel A) and 2 -47- (channel B).
Furthermore it is possible to record the channel A output signal via USB port
1 -46- or the master output via USB port 2 -47-.