Samsung HW-K950 Benutzerhandbuch Seite 7

Connecting the Subwoofer and Surround Speakers Manually if the
Automatic Connection Fails
c Before You Begin
• Make sure that the Soundbar, the subwoofer, and the surround speakers are plugged in.
• Make sure that the Soundbar is turned on.
1. Press and hold ID SET on the rear of the subwoofer and surround speakers for at least 5 seconds. The red
indicator at the rear of each speaker turns off and the blue indicator blinks.
POWER
LINK STANDBY ID SET
Rear of Subwoofer
2. Turn off the Soundbar.
3. Press and hold the VOL button on the remote control for at least 5 seconds with the Soundbar turned off
(OFF).
4. The ID SET message appears on the display of the Soundbar for a short period of time, and then
disappears.
5. When the blue indicators on the subwoofer and surround sound speakers blink, turn on the power by
pressing button on the right side of the Soundbar or on the remote control.
6. When the connection is successfully established, the blue indicators on the rear of the subwoofer and
surround speakers turn on without blinking.
c If the connection process fails, the blue indicators will flash continuously. Go to Step 1 and start again.
LINK STANDBY ID SET
ID SET
· 7 · English
LINK STANDBY ID SET
LINK
Rear of the Left and Right Surround Speakers
Right Side of the Soundbar
STANDBY ID SET