Using The Subwoofer (Sw-P270); Pre-Adjusting The Subwoofer Volume - Yamaha NS-P270 Bedienungsanleitung

Using the subwoofer (SW-P270)

1
2
VOLUM E
3
IN PUT
4
POWER
ON
OFF
1
Power indicator
Lights up in GREEN when the POWER switch
4 is turned ON; turns off when the POWER
switch is turned OFF.
2
VOLUME control
Adjusts the volume level. Turn the control
clockwise to increase the volume, and
counterclockwise to decrease the volume.
3
INPUT terminal
Input terminal for line level signals from the
amplifier.
4
POWER switch
Press this switch to the ON position to turn on
the power to the subwoofer. When the power of
the subwoofer is on, the power indicator 1 on
the rear panel lights up green. Press this switch
again to set it to the OFF position to turn off the
power of the subwoofer.
8
Rear panel
Pre-adjusting the subwoofer
volume
Before you use the subwoofer, first adjust the
volume balance between the subwoofer and the
front speakers by following the procedure below.
1.
Set the VOLUME control to minimum (0).
2.
Turn on the power to all other components.
3.
Press the POWER switch to the ON position.
The power indicator on the rear panel lights up
in green.
4.
Play a source that contains low-frequency
sounds. Adjust the amplifier's volume control to
the desired listening level.
5.
Rotate the VOLUME control gradually to adjust
the volume balance between the subwoofer and
the other speakers. In most cases, set the control
to a level at which you hear slightly more bass
than when the subwoofer is not used.
6.
Adjust the volume of the entire sound system
using the amplifier's volume control.
• If you replace the front speakers (NX-E270) with
other speakers, you must again balance the subwoofer
and surround speaker volume.
• For more information on adjusting the VOLUME
control, refer to "Frequency characteristics" on
page 11.