Pioneer PDP-S41 Bedienungsanleitung Seite 6

English
When using the hung on wall unit:
First install the Plasma Display on the wall with only the speaker mounting fittings and speaker cable attached to the display,
and then attach the speaker. (See page 3)
To facilitate attachment of wiring, it is recommended to complete the wiring on the sides of the Plasma Display before
mounting speaker to the display.
Caution
Be careful about the speaker mounting fittings when installing or connecting. This may result in injury.
3. Connect the supplied speaker cables to the back of the Plasma Display.
4. Place the Plasma Display on the mounting fittings of the hung on wall unit.
• For details, refer to the instruction manual supplied with the hung on wall unit.
5. Connect the other end of the speaker cables to the speaker.
4
Speaker mounting
screw (M5 x 10 mm)
When using the hung on
wall unit, do not use these
holes.
7. Tighten using the supplied screws (4 locations).
• Tighten the four screws in the order 1, 2, 3, 4 as shown in the drawing.
6
6. Place the speaker on the speaker mounting
fittings in the correct direction.
Speaker mounting screw
(M5 x 10 mm)
2
1
3
Speaker mounting screw
(M5 x 10 mm)