Pioneer PDP-S41 Bedienungsanleitung Seite 3

Plasma Display with the speaker installed
Speaker
mounting
screw
(M5 x 10 mm)
Speaker mounting fitting
(right side)
INSTALLATION ON THE PLASMA
DISPLAY
Perform installation according to the following steps 1 to 4.
NOTE:
Before attaching the speaker, please attach the table top
stand to the Plasma Display unit.
1. Attach the speaker mounting fittings to the
rear of the Plasma Display.
• Attach the fittings for right and left sides to the bottom
right and left on the rear panel of the Plasma Display using
the supplied screws.
• Tighten the two screws in the order 1 followed by 2.
1
2
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting for the
left side
(the fitting method is the same
as the fitting for the right side)
Speaker mounting
screw (M5 x 10 mm)
Speaker
Speaker cable
Label "L" is
affixed to the left
side fitting.
(Similarly, label
"R" is
affixed to the
right side fitting.)
Speaker mounting
fitting (center)
Bead Band
(Accessories of the Plasma Display)
2. Attach the center fitting to the lower center
on the rear panel of the Plasma Display.
• Attach the center fitting to the lower center on the rear
panel of the Plasma Display using the four supplied
screws.
• Tighten the four screws in the order 1, 2, 3, 4 as shown
in the drawing.
• When fitting the screws, place screws 1 and 2 through
the holes in the center fitting, and align screws 3 and 4
with the cutaway slots in the center fitting.
4
2
1
Speaker mounting
screw (M5 x 10 mm)
NOTE:
• See page 6 for speaker mounting procedures when using
the hung on wall unit.
English
Speaker
mounting screw
(M5 x 10 mm)
Speaker mounting
fitting (left side)
3
Speaker mounting fitting for
center
3