Positioning And Levelling; Water Drainage - Zanussi ZWG 6160 P Benutzerhandbuch

Positioning and levelling

Level the appliance by raising or lowering the feet.
The appliance M M UST be level and stable on a flat hard
floor. If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not level
and stable.
W W ater inlet
8
x 4
Connect the hose to a tap
with a 3/4" thread.
35°
Loosen the ring nut to angle the hose to the left or right
depending on the position of your water tap. D D o not
place the inlet hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut again to pre-
vent leaks.

Water drainage

Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in four
ways:
• H H ooked over the edge of a sink using the plastic
hose guide.
Tie the plastic hose guide to the tap with a string to pre-
vent that the drain hose unhooks when the appliance is
emptying.
• O O nto a sink outlet spigot.
45°