Zanussi ZWG 6160 P Benutzerhandbuch Seite 16

Start/Pause
7
At the end of the programme
The appliance stops automatically. The pilot light of the
button 7 7 and the pilot light corresponding to the just fin-
ished washing phase go off. The light 6 6 .3 illuminates.
If a programme or an option that ends with water left in the
tub has been selected and the door remains locked to in-
dicate that the water must be emptied out before opening
the door.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the rele-
vant button.
• Press the button 7 7 .
At the end of the programme, the door can be now
opened. Turn the programme selector dial to
the appliance off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Warning! If there are children or pets in the house,
activate the child safety device in the inner side of
1 1 6
S S tart the programme by pressing the button 7
• To s s tart the selected programme, press the button 7 7 , the corresponding
green pilot light stops flashing. The pilot light 6 6 .1 illuminates to indicate
that the appliance starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the countdown.
• To i i nterrupt a programme which is running, press the button 7 7 : the cor-
responding green pilot light starts flashing. It is possible to c c hange some
options of a running programme before the programme carries them out.
• To r r estart the programme from the point at which it was interrupted,
press the button 7 7 .
• After the programme has started the door is locked. If, for any reason,
you need to o o pen the door, set firstly the appliance to PAUSE by pressing
the button 7 7 . After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already heat-
ing or that the water level is too high. In any case, do not try to force the
door!
If you cannot open the door but you need to open it you have to switch
the appliance off by turning the selector dial to
the door can be opened (p p ay attention to the water level and tempera-
ture!). After closing the door, it is necessary to select the programme and
options again and to press the button 7 7 .
the door frame (for more details read " Child safety" in the
chapter "Safety Information").
lector dial and any button are not touched, after a few mi-
nutes the energy saving system is enabled. The pilot
lights go off. The green pilot light of the button 7 7 flashes
with a low frequency. By pressing any button the appli-
ance will come out of the energy saving status.
.
Door seal
to switch
Stand by: during programme setting up and once
the programme has finished, if the programme se-
At the end of every cycle,
check from the door seal
and remove objects that
could be trapped in the
fold.
. After a few minutes