Prior To The First Wash - Kenwood Mini 1150 rapid Bedienungsanleitung

Mod. Mini 1150 rapid
Adjustor lever in position 1
Attention: This position is essential whenever the machine is started.
Check that
• the machine is standing evenly on the floor and that it cannot slip.
• the machine is connected to the mains.
• the water intake and runoff hoses are properly connected (see page 4).
If you have to move the machine to a new position, always disconnect from
the mains and disconnect the water intake and runoff hoses first.
When disconnecting the hoses do no forget that they might still contain some
water.
Adjustor lever in position 2 = moving position
The machine can now be rolled on the four casters.
Attention:
The washing machine must be properly installed and connected.
The washing machine was tested before leaving the factory. To make sure that any traces of water
used in the test are removed, wash for the first time without introducing any dirty linen.
• do not put any dirty linen into the machine
• open the water cock
• place 1/ measuring cup of detergent in the chamber foreseen for the main detergent
• start the „easy-care / fine wash" programme at 60°C and let it run its course
The washing machine is now clean and ready for operation.
Connection and installation

Prior to the first wash

2
1
85