Connection And Installation - Kenwood Mini 1150 rapid Bedienungsanleitung

Open the loading door to remove both the fill and drain hoses:
• connect machine to electricity supply
• turn on main switch and switch programme selector to position "  ",
• wait until the digital display " 00 " stops flashing
• now switch the programme selector to the " " symbol
Mains water pressure
• The mains water pressure must be between 1 bar and 10 bar. If the pressure is higher a pressure
reduction valve must be fitted before the water enters the washing machine. Please comply with your
mains water supplier's conditions.
Water connection Mod. Mini 1150 rapid
• The washing machine is fitted with an Aquastop hose.
• Function:
• The Aquastop hose is encased in a corrugated hose. In the event of a fault
the this corrugated hose collects the water and an integrated valve stops the
water supply.
• A red spot appears in the warning window () indicated that the hose is
damaged. If this happens the Aquastop hose must be replaced. You can
order this from the after sales service.
• Connecting the Aquastop hose
• The appliance may only be connected up to the cold water supply.
• Mount the nut (3) on the tap and tighten (black arrow - see diagram).
• Check that it is watertight.
• Disconnecting the Aquastop hose:
• Cut off the water supply (turn off).
• press the yellow button (4) and unscrew the nut (3) (grey arrow - see
diagram).
Water connection Mod. Mini 1160 rapid
• It is intended for cold-water connection only.
• The washing machine is fitted with a water retention protection.

Connection and installation

S L
S
P -W A X
E P
-M
b a r
9 0 °C
-1 0
0 ,2
1
2
S L
S
P -W A X
E P
-M
b a r
9 0 °C
-1 0
0 ,2
3
S L
S
P -W A X
E P
-M r
°C b a
9 0
-1 0
0 ,2
3
4
S L
S
P -W
A X
E P
-M r
°C b a
9 0 -1 0
0 ,2
83