End Of Programme; Maintenance And Cleaning; Cleaning The Detergent Drawer - Blomberg WMI 7462 WE20 Bedienungsanleitung

Selection knob to Pump+Spin programme and
discharge the water in the machine.
Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol illuminates
when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine
is in this mode:
Adjust the spin speed and press Start / Pause /
Cancel button. Pause symbol disappears and Start
symbol appears. Programme resumes, discharges
the water and spins the laundry.
If you only want to drain the water without spinning:
Just press Start / Pause / Cancel button. Pause
symbol disappears. Start symbol appears.
Programme resumes and discharges the water
only.

End of programme

"End" appears on the display at the end of the
programme. Symbols of the programme steps
remain lit. Auxiliary function, spin speed and
temperature that were selected at the beginning of
the programme remain selected.

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.

Cleaning the detergent drawer

Remove any powder residue buildup in the drawer.
To do this;
1
You can remove the detergent drawer by pulling it
towards yourself strongly.
If more than a normal amount of softener and
C
liquid detergent mixture starts to remain in the
softener compartment, the siphon must be
cleaned.
Wash the drawer and the siphon with plenty of
lukewarm water in a washbasin. Wear protective
gloves or use an appropriate brush to avoid
touching the residues in the drawer when cleaning.
Replace the drawer into its housing after cleaning.
Check if the siphon is in its original location.
Cleaning the loading door and the drum
Residues of softener, detergent and dirt may
accumulate in your machine in time and may cause
2
3
4
15
unpleasant odours and washing complaints. To
avoid this, use the Drum Cleaning programme. If
your machine is not featured with Drum Cleaning
programme, use Cottons-90 programme and
select Additional Water or Extra Rinse auxiliary
functions as well. Before starting the programme,
put max. 100 g of powder anti-limescale into the
main wash detergent compartment (compartment
nr. II). If the anti-limescale is in tablet form, put only
one tablet into compartment nr. II. Dry the inside
of the bellow with a clean piece of cloth after the
programme has come to an end.
Repeat Drum Cleaning process in every 2
C
months.
Use an anti-limescale suitable for the washing
C
machines.
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is
blocked, open the holes using a toothpick.
Foreign metal substances in your machine will
C
cause rust stains. Clean the stains on the drum
surface by using cleaning agents for stainless
steel. Never use steel wool or wire wool.
Cleaning the body and control panel
Wipe the body of the machine with soapy water
or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the control
panel.
Never use sponge or scrub materials. These
A
will damage the painted and plastic surfaces.
Cleaning the water intake filters
There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected
to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine.
Filters should be cleaned as they do get dirty.
EN