Mains Input; Back Panel Connections - T+A G 1260 R Betriebsanleitung

GND
   
OUT
 
 
R
    LINK

Mains input

 
 
Connections
Earth (ground) clamp
Only for G 1260 R version without internal phono module.
Connect this terminal to the earthing point on your amplifier.
Do not use if internal phono module is installed.
Output sockets
If your G 1260 R version is not supplied with a factory-fitted PHONO pre-
amplifier module:
Connect these sockets to a PHONO input on your amplifier.
Please note: if the G 1260 R is not fitted with a phono module, this facility must
   
be present in your amplifier or receiver.
If your G 1260 R is supplied with a factory-fitted PHONO pre-amplifier
module:
Connect these sockets to a high-level (line) input on your amplifier.
Use one of the following inputs to connect the G 1260 R, depending on your
   
model of amplifier:
Input Device
AUX 2 P1230/1260R, PA1230/1260R, PA1530R, R1530 R
AUX1 R1230R
Control input for connecting to  units with the R
 PA 1260 R amplifier).
The mains lead should be connected to this socket.
26
control system (e. g.
LINK