Front Panel Controls; Playing A Disc - T+A G 1260 R Betriebsanleitung

       
33 / 45

Playing a disc

Operation

Front panel controls

(On / Off switch)
A brief press on the 
machine is switched on, the indicator light above the button glows.
If the turntable is used in conjunction with an R-system, the G 1260 R is
switched on via the existing R
"AUX2" as listening source. When you switch the R-system off, the G 1260 R is
automatically switched off.
Caution!
 
 
   
The mains button is not a mains isolation switch. Even when the LED is
not glowing parts of the machine remain connected to the mains power
supply (Standby mode). The stand-by current drain is stated in the chapter
entitled 'Specification'.
If the unit is not to be used for a long period we recommend that you
disconnect the mains plug at the wall socket.
Disc speed select button
When the disc platter is stationary, pressing one of the buttons starts the platter
motor running at the rotational speed stated above the button. The LED above
the button flashes while the motor runs up to speed. The LED glows constantly
as soon as the nominal speed is reached.
Simply press the other of the two buttons to change the disc speed.
Stopping the platter motor
When the disc platter is turning, it can be stopped by briefly pressing the button
below the glowing LED: the platter is actively braked, and comes to rest after a
brief period.
• A brief press on the 
• Place the disc on the platter.
• We recommend that you always remove superficial dust from the disc before
you play it, e.g. using a carbon fibre brush or an anti-static cloth.
• Press the 33 or 45 rpm button (as required by the disc on the platter) in order
to start the motor.
• Move the tone arm inward until it is above the desired groove. the LED above
the selected disc speed button glows constantly when the nominal speed is
reached, indicating that you can slowly lower the tone arm onto the disc by
operating the tone arm lift lever (
ton arm', chapter 'Fitting the counterweight, checking the tone arm').
If you are using the optional cover, you must remove it before operating the
   
G 1260 R.
 button switches the unit on and off. When the
 
connection when you select the phono input
LINK
 button switches the machine on.
 
 , see illus. 'Adjusting elements on the
 
24