Cleaning The Exhaust Filter - Electrolux Z 8234 Bedienungsanleitung

14
1180066-21.indd 14
30 31
32 33
34 35
English

Cleaning the exhaust filter

There are two types of Electrolux Twinclean exhaust filters:
• Standard filter. Must be cleaned every 5–7 years.
• HEPA filter (thicker with creased fibre material). Must be
cleaned every 2–3 years.
There is no difference in how the filters are cleaned or
fitted.
30 Remove the dust container by pressing the release
button at the back of the vacuum cleaner and lifting
the container.
31 Lift the two snap catches at the back edge of the
vacuum cleaner and open the filter cover.
32 Lift out the filter.
33 Rinse the inside (dirty side) in lukewarm tap water.
Tap the filter frame to remove the water. Repeat the
process four times. Note: Do not use cleaning agents
and avoid touching the filter surface.
Let the filter dry.
Put the filter back into place, close the filter cover and
refit the dust container.
Clearing the hose and nozzle
The vacuum cleaner automatically stops if there is a
blockage in the nozzle, tubes or hose or if the filter or filter
holder becomes blocked. Pull out the power plug and
allow the vacuum cleaner to cool down for 20–30 minutes.
Remove the blockage that is causing the problem, and/or
replace the dirty filter. Restart the vacuum cleaner.
34 Use a suitable implement to clear the tubes and hose
of blockages.
35 It is sometimes possible to clear the hose by
"massaging" it. However, be careful in case the
obstruction has been caused by glass or needles
caught inside the hose. Note: The warranty does not
cover any damage to hoses caused by cleaning them.
2/4/08 4:47:38 PM