Clatronic bs 1236 Bedienungsanleitung Seite 41

5....-05-BS 1236
Vacuum power regulator (see illustration D):
Low vacuum power:
Medium vacuum power:
High vacuum power:
Instructions for Use
• Now you should vacuum at an even speed. Pressing hard is not necessary.
• Note: Pay attention to the restricted range due to the length of the cable!
• Avoid damaging the surface being cleaned:
• Do not set the brushes too low!
• Do not allow the machine to remain stationary when switched on!
Using the Accessories
The accessories should only be replaced when the machine is switched off.
• Release the suction hose (8) from the hose connection (17).
• Select the desired accessory and place it on the end of the suction hose.
• If the hose is too short, attach the suction tubes beforehand as an extension.
Switching off
• Move the handle to a vertical position (a). See illustration E.
• Switch the device off using the on/off switch.
• Use the cable take-up to stow away the cable.
Filter:
Your machine has three filter systems.
1. Transparent dust collection container
• The traditional dust bag system has been replaced by a transparent dust collec-
tion container in which coarse dirt particles and tiny particles floating in the air
are swirled out of the suction air by the high speed of the air current.
• The quantity of dust can be easily read off at any time on the container, which
is also very easy to empty.
• The purchase of dust bags is no longer necessary.
2. Pre-filter, Foam Filter, Motor Protection Filter (in the Dust Container)
• Once the dust level has reached the FULL mark of the dust container, please
proceed as follows:
1. Open the front panel (3) by pulling the opener (2).
2. Remove the dust container. See illustration F.
3. Empty the contents of the dust container into a suitable receptacle by pres-
sing button 24 on the dust container. See illustration F.
05.03.2004 10:41 Uhr
For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
Seite 41
41
GB