Switching On And Off; Displaying The Time In Tv Mode; Presetting Stations; Function - Metz Florida VT 37 TF 31 Bedienungsanleitung

Switching on and off

Switching on
If the TV set is cold and is placed in a warm room, wait
for any condensation on the screen to evaporate before
switching the set on.
Switch the TV set on by pressing the main switch.
The TV set is now in standby mode, indicated by a red light.
Single-digit programme positions can be selected with the numeri-
cal keys . . . or with the keys P
control or with the - P + keys on the TV set
When the TV set is on, two-digit programme positions can be selec-
ted by pressing the preselection key for two-digit input, followed by
the numerical keys.
Switching off
Pressing the OFF key on the remote control switches the TV set to
standby mode. Pressing the main switch on the TV set switches the
set off completely.

Displaying the time in TV mode

In order to display the time, first press the
press the time key once. When the TV set is tuned to a station
which transmits teletext, the time will appear in white figures on a
blue background. Pressing the Time key again switches off the time
display.
When you switch the TV set on for the first time (with no stations
already stored), the following message is displayed on the screen:
In this state, the TV set will switch itself off after about five minutes if
you do not press any keys on the remote control.
Now press the
or P on the remote
switched the TV set on for the first time, the table displayed here is
empty.
Press the blue key on the remote control. The following message is
displayed on the screen:
This function can be cancelled by pressing the
key twice and then
The A.P.S. function is started by pressing the
The TV set now searches the entire terrestrial reception range (recei-
ved with an antenna or from cable) for stations.
After the search has been completed, the station table is displayed
on the screen. This could, for example, look like this:
In some cases, the station logos may not be recognised during the
station search. In this case, you can enter the station a logo as
described on page 30.
The various programme positions in the station table can be selec-
ted with the cursor keys.
You can then do the following with the selected programme position:
SELECT =
INSERT =
DELETE =
AUTOSTORE = calls the A.P.S. function
• Close the menu by pressing the

Presetting stations

NO SIGNAL
5:00
key to display the PROGRAM. menu. If you have
i
WARNING !
All prestored programmes
will be erased
Continue
–
Cancel
PROGRAM.
01 PR01 11 PR11
02 PR02 12 PR12
03 PR03 13 PR13
04 PR04 14 PR14
05 PR05 15 PR15
– – – –
06 PR06 16
– – – –
07 PR07
17
08
– – – –
PR08 18
09 – – – –
PR09 19
10 – – – –
PR10 20
SELECT
INSERT
pressing the red key selects this programme position
the programme position selected with the red key
can be inserted in another position in the table
deletes the programme position
T V key.
key.
key.
– – – –
21
– – – –
22
– – – –
23
– – – –
24
– – – –
25
– – – –
26
– – – –
27
– – – –
28
– – – –
29
– – – –
30
DELETE
AUTOSTORE
29