Start-Up Of The Device / Introduction - AEG MRC 4151 Bedienungsanleitung, Garantie

7 VOL + button
8 VOL − button
9 ALARM button
10 MEM / PRESET button
Display
A Radio mode
B Alarm time 1
C Alarm time 2
D Snooze active
Rear view (without illustration)
Dipole antenna
Power adapter socket – DC 5 V
AUX jack
Bottom (without illustration)
Battery compartment

Start-up of the device / Introduction

• Choose a suitable location for the device. Suitable
would be a dry, level, non-slip surface.
• Sensitive surfaces such as the display may be pro-
tected by plastic foil. Remove this foil.
• Set the device onto the smartphone holder. (Smart-
phone not included in the scope of delivery)
Power supply
1. Make sure the grid voltage corresponds to the
fi gures on the rating plate.
2. Insert the grid plug into a properly installed three
prong socket.
3. Connect the device with the plug connector by
inserting its plug into the "DC 5 V
the device.
CAUTION:
• Only use the supplied power adaptor for this
device. Do not use for other devices.
• Only use power adaptor with 5 V (
adaptors may cause damage to the device.
NOTE:
• Disconnect from mains power supply during
longer periods of non-use.
• If you did not insert another reserve battery, the
time and the station memory will be lost as soon as
the power supply is interrupted.
Inserting the reserve batteries (not supplied)
In case of power failure or if the power supply unit is
pulled from the plug, the settings are maintained if the
reserve batteries are inserted.
1. Open the battery compartment on the bottom side.
MRC4151_IM - Size 138x210mm
2. Insert 2 type R 03 "AAA" 1.5 V batteries. Check that
the polarity is correct (see battery compartment).
3. Close the battery compartment.
WARNING:
The batteries shall not be exposed to excessive heat
such as sunshine, fi re or the like. Danger of explo-
sion!
CAUTION:
• Batteries can leak battery acid. If the device is
out of use for a long period of time, remove the
batteries.
• Different battery types or new and used batteries
must not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at
the relevant collection bin or at your dealer' s .
Switching the device on / off
Switching on: Press the
Switching off: Press and hold the
Adjusting the volume
Adjust the volume using the VOL − / VOL + buttons.
Temperature display
Proceed as follows to display the temperature.
1. Turn the device on.
2. Press the
shown in the display.
• You can use the buttons
the temperature display between (degrees Centi-
" jack of
grade) and (degrees Fahrenheit).
NOTE:
During the temperature display, no sound is possible.
Change the Colour of the Mood Light
), other
During operation, the upper housing of the device is
illuminated. You can select between 7 different colour
variations and automatic color change.
1. Press the SNOOZE /
the desired color.
2. With the 8th color selection, the illumination auto-
matically changes between the 7 colour variations.
You also can switch off the illumination:
• Press the SNOOZE /
• To turn the illumination on again, press the
SNOOZE /
CAUTION: You can not replace the LED lamps.
English
FUNC button.
FUNC button for
approx. 3 seconds.
FUNC button until the temperature is
and Tto switch
button repeatedly to select
button for 3 seconds.
button again for 3 seconds.
30.03.16
29