Cera Divino Anleitung Seite 55

The first layer of
storage bricks
consists of two
bricks with bevelled
"wings" and three
smaller bricks. The
wing bricks are . .
. . ... the second
layer is placed on
the first in a mirrored
position (with the
bevelled sides
facing upwards)...
In the third layer, the
small bricks are at the
back and front . . .
The last layer starts at
the back of the stove
using three small
fireclay bricks ... . .
Now put the cover
plate back on,
Flue pipe connection:
If the flue pipe is connected on top, the three small segment storage brickbricks are fitted; if the flue pipe connection is to
the rear only two bricks are fitted, the middle brick is left out. To conclude, the end profile is put in place: if the
connection is upwards, without an inner plate, if the flue pipe connection is to the rear, with an inner plate (round
cover).
Fitting the fireclay storage bricks
on the Divino uno / due / tre
End profile
. . . and then place the small
54
. . . inserted with the
bevels facing
downwards (in the
bottom half of the
stove), then three
smaller bricks are
placed in the front area .
. . . and then
completed with the
three smaller bricks.
The third row is
completed with two
segment bricks
with bevels (on the
underside).
. . . and is completed
again with two
segment bricks with
bevels (facing
opposite the third
row).
cover inside (if the chimney
connection is to the rear).
After this, screw the closing
cover back on and put the
stove cover in place.
. .