Cera Divino Anleitung Seite 54

Assembly of Divino feed air connection "at rear"
If the air feed is carried out from the rear, the rear side must be "opened" under the steel jacket.
the opening has already been glazed and is only connected to the rear panel walling with
small webs.
The rear wall panel is placed on
the floor, and the adapter sheet
with feed air connection is located
53
In this case
Now cut through these webs
These webs have to be cut
through and the panel has
to be removed so that a
feed air duct can be fitted
to the feed air connection
from the rear.
The feed air opening cover
can now be seen on the
corpus under the sheet you
have just removed. Remove
this cover sheet (fixed with
two screws) and. . . screw
the feed air connection on
at this location. The feed air
pipe can now be connected
here.
The cover plate
screwed on at the rear now has
to be screwed over the opening
in the floor panel (underneath
the ash pan compartment) with
its seal facing upwards, so that
no more room air can flow in
here.
previously