Connecting Auxiliary Audio Equipment; Additional Information; Maintenance - Sony CDX-CA900 Bedienungsanleitung

Connecting auxiliary audio
equipment
The unit's AUX IN (external audio input)
terminal on this unit is also used as the BUS
AUDIO IN (audio input) terminal.
You can listen to the sound from your car
speakers by connecting an optional Sony
portable devices.
Note
If you connect an optional Sony CD/MD unit, you
cannot connect any portable devices and cannot
select "AUX."
Selecting auxiliary equipment
Press (SOURCE) repeatedly to select
"AUX."
Adjusting the volume level
You can adjust the volume for each connected
audio equipment.
1
Press (MENU), then press M or m
repeatedly until "AUX Level" appears.
2
Press (ENTER).
3
Press M or m repeatedly to select the
desired volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
4
Press (MENU) twice.
After the setting is complete, the display
returns to normal playback mode.
To deactivate auxiliary equipment in
the music source display
1
Press (OFF).
CD/MD playback or radio reception stops
(the key illumination and display remain on).
2
Press (MENU).
3
Press M or m repeatedly until "AUX-
A·····on" appears.
4
Press , to select "AUX-A····off."
5
Press (MENU).
To restore the indication, select "AUX-A·····on."
26

Additional Information

Maintenance

Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 8) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.
Main unit
Back of the front panel
Fuse (10 A)