Unpacking The Appliance; General Notes On Use; Functionality Of The Device; Electrical Connection - BOMANN KM 1390 CB Bedienungsanleitung

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

20 Blender jug

21 Seal ring

22 Knife block

Unpacking the Appliance

WARNING: Risk of injury!

Some parts of the accessory are very sharp!

1. Remove the packaging of the appliance.

2. Remove all packaging material such as plastic film, filler

material, cable ties and box packaging. Keep the blade

guard of the dicing cutter for appropriate storage.

3. Check that all parts are in the box.

4. If the packaging content should be incomplete or if dam-

ages should be noticeable, do not operate the appliance.

Return it to the distributor immediately.

NOTE:

Dust or production residues may still be found on the

appliance. We recommend that you clean the appliance as

described under "Cleaning".

General Notes on Use

Functionality of the device

• The appliance is equipped with safety switches. The appli-

ance can only be operated if you observe the following:

- When fitting onto the motor housing, the working bowl

or the blender jug with the knife block must audibly

click into place.

- When using the working bowl, either the lid or the filter

sieve must audibly click into place onto the bowl.

• Turn the control knob to select the speed. Always start

slowly with a low speed.

• PULSE = Pulse mode: Hold the control knob in this posi-

tion to run the appliance at the maximum speed setting.

• 0 is the off position.

CAUTION:

• Always set the control knob to 0 before plugging in.

Table of Use of the Accessories

Observe the maximum operating times and pause times!

Product / Type of preparation

Mix food with liquids

Nuts

Herbs

Chocolate (cut into pieces)

Cut meat into pieces

Chop onions, carrots, potatoes,

cucumber

KM1390CB_IM

• Disconnect the plug from the socket after use.

Electrical Connection

Ensure that your mains power corresponds with the specifi-

cations on the type label.

Assembly of the Accessories

The cutting inserts and the dicing blade are very sharp

on the cutting / grating surfaces and the edges! Therefore

use these accessories with the necessary care to prevent

injuries.

Attachment holder for cutting inserts (16)

The attachment holder has 3 different inserts. Remove the

inserts by pulling the tab of the insert forward and then up.

Use the recesses of the attachment holder to insert the

attachments.

Attachment taper for dicing blades and kneading hooks (4)

Insert the dicing blade or the kneading hook onto the attach-

ment holder. Press the attachment up as far as possible.

Fitting the Bowl

1. Place the guide pin onto the drive shaft of the motor

3. Select an attachment. Place it onto the guide pin.

4. Close the working bowl with the lid. Tighten it by turning

Amount

Max. 1500 ml

Blender jug

Min. 200 g