Product Set-Up; Default Setting - D-Link DSL-2745 Installationsanleitung

PRODUCT SET-UP

DEFAULT SETTING

Router Power Supply
Router
Telephone
Router
Wall socket
Internet
Save
4
Step 1
Power Adapter Connection
Plug the Power adapter Unit into the wall outlet and then connect
the other end of it to the Power port of the router (12VDC IN). Switch
on the plug point on.
Step 2
LAN connection
Connect the Ethernet LAN cable to any (Yellow) port on the router
and connect the other end to the LAN port of the PC.
PC
Step 3
DSL Port Connection
Connect the (DSL) port of the Router, using the (gray) telephone
cable to the port marked ( DSL) on the splitter. Connect the short
(Line) cable attached to the splitter to connect the telephone wall
socket.
Step 4
From the computer you connected to the router, open a web browser
and go to http://192.168.1.1. Enter admin as the User Name and
Password, and you may use the Setup Wizard to configure your
DSL-2745.
IP ADDRESS:
USERNAME:
PASSWORD:
http://192.168.1.1
admin
admin
DSL-2745