Philips HD8827 Bedienungsanleitung Seite 28

English
28
There is water under the
machine.
The machine does not
switch on.
The drip tray is quickly
filled.
The brew group cannot
be removed.
The brew group cannot
be inserted.
The coffee has too little
crema or is watery.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
The machine is disconnected.
This is normal. The machine uses
water to rinse the internal circuit
and brew group. Some water
flows through the internal system
directly into the drip tray.
The brew group is not positioned
correctly.
The coffee grounds container is
not removed.
The machine is still in the
descaling process.
The brew group is not in the
correct position.
The grinder is set to a coarse
setting.
The brew group is dirty.
The coffee exit duct is dirty.
The coffee blend is not the
correct one.
Empty the drip tray when the drip tray
full indicator pops up through the drip
tray. Always empty the drip tray before
you start descaling the machine.
Place the machine on a horizontal
surface so that the drip tray full
indicator works properly.
Check if the power supply cord is
inserted correctly.
Empty the drip tray when the 'drip tray
full' full indicator pops up through the
drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
Close the maintenance door. Switch
the machine off and back on again.
Wait for the machine ready screen to
appear and then remove the brew
group.
Remove the coffee grounds container
before removing the brew group.
You cannot remove the brew group
when the descaling process is active.
First complete the descaling process
and then remove the brew group.
The brew group was not put in rest
position before it was placed back.
Make sure that the lever is in contact
with the base of the brew group and
that the hook of the brew group is in
the correct position.
Reset the machine by switching it on
and off. Place the drip tray and the
coffee grounds container back. Leave
the brew group out. Close the
maintenance door and switch the
machine on and off. Then try to
reinsert the brew group.
Adjust the grinder to a finer setting.
Clean the brew group. For thorough
cleaning, follow the monthly cleaning
procedure with the degreasing tablet.
Clean the coffee exit duct thoroughly
with the handle of the multifunctional
tool or a spoon handle.
Try another coffee blend.