XciteRC Brushless-Gimbal 2-Achsen 15001150 Bedienungsanleitung Seite 3

2-axis brushless gimbal
Getting Started Guide 2-axis brushless Gimbal Rocket 400 GPS
Thank you for purchasing the 2-axis brushless gimbal for the quadrocopter Rocket 400 GPS. The
gimbal is pre-wired and mounted on the quadrocopter in minutes.
1. Installation
2. Connection
5 V
S
12 V
+
3. Operation
Rocket 400 GPS 2-axis brushless gimbal
Secure the gimbal with the two screws on the bottom of
the quadrocopter as in the picture.
Connect the power cable (red plug) withthe black wire to
the outside in the 12 V socket on the quadrocopter. Insert
the control lines (black connector) with the black wire to the
outside in the 5 V jacks.
WARNING: Observe polarity - heat generation and
fire hazard!
Pitch and roll of the gimbal can be changed during the flight
with the two knobs AUX1 and AUX2 on the transmitter.
EN
3