Back (Languedoc); Back (Normandie) - Vermeiren Provence Gebrauchsanweisung

BACK (Languedoc)

The pneumatic spring is connected with the back frame with a locking pin (1) to assemble the back.
Erect the back frame until the sockets on the lower back frame and the suspension eye of the
A
pneumatic spring lie over one another.
Guide the locking pin (1) through the back sockets and the pneumatic spring. Two plastic
B
washers are to be inserted before and after the pneumatic spring socket as a spacer guide.
Afterwards, secure the locking pin (1) by guiding the tension spring (2) over the pin until it
projects out over the end of the spanning pin.
A

BACK (Normandie)

In addition to the back assembly (see section "Back Languedoc"), for the Normandie model the leg
support (A) is connected to the back frame with the supports (B).
For assembly, you should lay the model on a flat surface on its side.
1
C
B
B
C
1
L
Tighten the screws only to the extent that the mechanism can still move, but the screw must at
least be guided through the self-locking nut.
B
A
6
1
Bring the mechanism for the leg support (A)
into position so that the fixing poles (B) and
the suspension loops on the lower back frame
(C) lie over one another.
Guide the screws (1) from the outside to the
inside through the holes on the suspension
loops on the back frame (C) and on the fixing
poles (B) and secure them with self-locking
nuts.
FAUTEUIL REPOS
2
GB