Compliance-Hinweis - DJI RONIN-MX Bedienungsanleitung

Betriebsleistung
Zuladung
(Richtwert)
Kontrollierte
Winkelgenauigkeit
Max. geregelte
Drehgeschwindigkeit
Mechanischer
Endpunktbereich
Steuerbarer Drehbereich

Compliance-Hinweis

Compliance-Hinweis FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Belichtungsinformation RF
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not be less than 20cm during normal operation.
4,5 kg
±0,02°
Schwenkachse: 200°/s
Neigungsachse: 100°/s
Rollachse: 30°/s
Steuerung Schwenkachse: 360° durchgehend
Steuerung Neigungsachse: +270° bis -150°
Steuerung Rollachse: ±110°
Steuerung Schwenkachse: 360° durchgehend
Steuerung Neigungsachse: +45° bis -135°
Steuerung Rollachse: ±25°
Ronin-MX Bedienungsanleitung
©
2016 DJI Alle Rechte vorbehalten
47