Stiga Mirage 5.0 Gebrauchsanweisung Seite 41

6 MISCELLANEOUS
6.1 Cutting deck
6.1.1 Dismantling
Carry out preparations. See "5.2".
Remove the cutting deck as follows:
1. Remove the starter key from the start switch.
2. Lower the cutting deck to the working position.
3. Disconnect the cutting height setting cable
(7:A).
4. Disconnect the signal cable (7:B).
5. Disconnect the power supply cable (7:C).
6. Unhook the chain (9:F) from the implement lift-
er.
7. Remove the pins (15:G) from both sides.
8. Depress the lever (15:F) on both sides and un-
hook the cutting deck.
6.1.2 Assembly
Carry out preparations. See "5.2".
Install the cutting deck as follows:
1. Remove the starter key from the start switch.
2. Hook the cutting deck arms into place on both
sides according to fig. 16.
3. Lock the arms by twisting the lever arms up
(17:F) on both sides.
4. Install the pins (15:G) on both sides.
5. Hook the chain (9:F) into the outermost hole in
the implement lifter.
6. Connect the power supply cable (7:C).
7. Connect the signal cable (7:B).
8. Connect the cable for cutting height setting
(7:A).
ENGLISH
7 SERVICE LIST
GGP reserves the right to make alterations to the
product without prior notification.
GB
41