Stiga Mirage 5.0 Gebrauchsanweisung Seite 35

2.4.7 Start switch (1:E)
The start switch is used to activate/switch off the
machine.
Never leave the machine with the key in
the operating position. Children or un-
authorised persons could drive off with
the machine.
Two positions:
1. Stop position – the machine is switched
off and the parking brake is activated. The
key can be removed.
2. Operating position – the machine is ac-
tivated after remedial action according to
4.2. If the machine is left while it is acti-
vated, there will be a warning signal after
5-10 seconds with a regular beeping.
Stop the machine by turning the key to stop posi-
tion 1.
2.4.8 Display (3:P)
The display shows the following:
See fig. Designation Note
3:P Error mes-
sages
4:Q Battery status See 2.4.10
4:R Power con-
sumption
4:S Operating
mode
4:T Speed
4:U Hour meter
4:V Speed setting See 2.4.14
2.4.9 Error message
In the event of a fault with the machine the relevant
error message is shown in the display.
The messages are divided into two categories and
the relevant symbol is shown in the display:
Information that does not require special
remedial action.
Condition that must be rectified before it
is possible to continue.
Some of the most common error messages are de-
scribed below
Name
65 MOTOR
TEMPERATURE
ENGLISH
Displaying error mes-
sages.
See 2.4.9.
Graphically displays the
power being supplied by
the batteries.
See 2.4.13.
Displayed in km/h.
See 2.4.11
Action
Stop the machine and run
the cutting deck for 30-60
seconds without the
blades working.
66 BATTERY LOW
79 INCORRECT
START
A205 DECK LIFTED Deck in lifted position.
209 HIGH LOAD
223 SHUT OFF
224 BATTERY
SHUTDOWN
225 BATTERY
CRITICAL
226 BATTERY
WARNING
A242 BLADE
MOYTOR SENS: KO
A30 BLADE VMN
LOW
A241 NO CUTTING
DECK
If the fault cannot be rectified according to the ta-
ble above or if other faults are shown, contact an
authorised workshop.
GB
The battery has reached a
low level. Go to charging
point. Connect for charg-
ing.
Not all start conditions
have been met.
Switch off the system and
activate the machine cor-
rectly.
Lower the cutting deck.
Reduce the power con-
sumption
The machine has not been
used for 2 minutes and
has switched to Standby.
Restart the machine.
The machine has been op-
erated for too long and the
battery has reached the
safety level and the ma-
chine has shutdown.
Transport to charging
point. Connect for charg-
ing.
The battery has reached
critical level and the cut-
ting deck has shutdown.
Go to charging point.
Connect for charging.
The battery has reached a
low level. Go to charging
point. Connect for charg-
ing.
A. The sensor cable to the
cutting deck is not con-
nected
B. Contact a service
workshop
A. The power cable to the
cutting deck is not con-
nected
B. Contact a service
workshop
A. The cutting deck has
been disconnected
B. Contact a service
workshop
35