Stiga Mirage 5.0 Gebrauchsanweisung Seite 36

GB
2.4.10 Battery indicator (4:Q)
The battery indicator displays the battery status as
follows.
• Battery status during operation.
• Charging status and battery status during charg-
ing after pressing one of the display buttons.
Fully charged batteries are indicated by 100%
or 100 E%.
2.4.11 Hour meter (4:U)
The machine is fitted with an hour meter that dis-
plays the number of hours that the machine has
been in operation.
2.4.12 Starting the cutting deck (1:G)
A button for engaging and disengaging the electri-
cal drive for the cutting deck.
When the cutting deck is activated the machine can
only be operated at working speed.
2.4.13 Operating mode (3:BL)
The machine can work in two operating modes:
N
Normal mode. The cutting deck works at full
speed and is given maximum current when
necessary.
E
Eco-mode. The cutting deck works at a re-
stricted speed and current.
Press the button (3:BL) to switch between the
modes.
The selected mode is displayed in the box (4:S).
2.4.14 Speed setting (3:BR)
The machine can work in two different speed set-
tings:
• Transport speed (approx 0-10 km/h). Indicated
by a hare.
• Working speed (approx 0-6 km/h).
2.4.15 Cutting height, setting
The cutting height can be raised and lowered step-
lessly using the 3:BT and 3:BD buttons.
The cutting height can be adjusted between 30 and
90 mm.
36
ENGLISH
2.4.16 Indicator lamps
The machine has the following indicator lamps:
See Indicates
fig.
3:M Battery status See 2.4.17.
3:N Fault in cut-
ting deck
3:O Too high load When the lamp lights; Cut/
2.4.17 Warning signals
The machine is equipped with a high frequency
buzzer that, together with the warning lamps,
makes up the machine's warning system.
The following warning signals are relevant:
Signal
Short repetitive
sound alerts
3:M lights con-
stantly and the
buzzer sounds 4
times over 7
seconds
3:M flashes con-
stantly and the
buzzer sounds
constantly with
short repetitive
sounds.
2.4.18 Seat (1:A)
The seat can be folded and adjusted front-
rear. The seat can be adjusted as follows:
1. Move the control lever (1:B) upwards.
2. Set the seat to the desired position.
3. Release the control lever (1:B) to lock
the seat.
The seat locks automatically in the folded up posi-
tion, to fold the seat down again, release the catch
(2:L).
The seat is equipped with a safety switch that is
connected to the machine's safety system. This
means that certain dangerous activities are not pos-
sible when there is nobody sitting on the seat. See
also 4.1.2.
Explanation/Remedial
action
The lamp lights in event of
high temperature, blocking
or too high current.
Stop the machine, discon-
nect the current to the cut-
ting deck and clean the
cutting deck.
drive more slowly or in-
crease the cutting height.
Description Action
The driver has Switch off the
left the machine.
machine with-
out switching
it off.
Battery level Prepare to stop
low. cutting.
Battery level Stop cutting.
critical. The
Put the machine
cutting deck
on charge.
switches off.