Asus RP-N12 Handbuch Seite 9

Setting up the Range Extender
Turning the Range Extender on
1. Place RP-N12 near your Router/AP.
2. Plug RP-N12 to a power outlet, wait for one (1) minute until
the Wi-Fi LED starts to blink.
Connecting to a network
Select one of the following ways to connect the Range Extender
to a network.
Option A: Connecting through GUI
1. Use a Wi-Fi enabled device, such as your desktop PC/note-
book/tablet, to find and connect to ASUS_RPN12 wireless
network.
2. Launch a web browser and enter http://repeater.asus.com in
the address bar to access the Range Extender.
3. Enter the default login name and password, which are admin/
admin.
4. Follow the Quick Internet Setup steps below to set up the
Range Extender:
u10206_RP-N12_QSG.indb 9
• Connect to a Wi-Fi network and when prompted, enter the
security key. If your Wi-Fi network is hidden, click Manual
setting.
• You can either tick "Use default setting" or enter the SSID
and security key/password for your extended network. When
done, click Next.
NOTE: The Range Extender's wireless network name (SSID)
changes to your existing Wi-Fi network name, ending with _RPT
and shares your router/AP's Wireless Password.
• Connect your wireless devices to the new Extender network.
Option B: Using WPS (Wi-Fi Protected Setup)
1. Press the WPS button on the router/AP.
2. Press the WPS button on the side of the RP-N12 for more than
two (2) seconds, until the Wi-Fi LED starts to blink.
NOTE: Refer to the router's manual for the location of the WPS
button.
9
2015/4/13 21:21:45