Status Displays; Transmitter Module (Neo-Fiberlink-2Tx); Front Panel - G&D NEO-FiberLink-2 Installationsanleitung

Status displays

Both the transmitter and the receiver module provide different LEDs.
The LEDs on the front panel allow you to control the modules' operating status at
any time
The Transmission interfaces at the back panels of the modules provide additional
LEDs that inform the user about the data connections.

Transmitter module (NEO-FiberLink-2Tx)

Class 1 Laser Product
Transmission Fiber Transmission-1 CAT
Tx Rx

Front panel

Section LED
Power Red.
Main.
Status Trans.
System
Transmission-2 CAT
to slave / lower-level device
Status Meaning
on The optional power pack is connected and supplies the
required voltage.
off The optional power pack is not connected, or the
connection to the mains could not be established.
on The power pack is turned on and supplies the required
voltage.
off The power pack is not connected, or the connection to
the mains could not be established.
on Working data connection between transmitter and
receiver module.
off Interrupted data connection between transmitter and
receiver module
blinking The transceiver module is ready for operation.
off The transceiver module is turned off.
Status displays
Power Status
Red. Trans.
Main System
Red. Power
NEO-FiberLink-2 · 7
Service