Connecting The Receiver Module (Neo-Fiberlink-2Rx); Start-Up - G&D NEO-FiberLink-2 Installationsanleitung

Start-up

Connecting the receiver module (NEO-FiberLink-2Rx)

Place the receiver module close to the slave matrix switch.
Class 1 Laser Product
Transmission Fiber
Tx Rx
Transmission – Tx: Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the Transmission – Rx interface of the
receiver module.
Transmission – Rx: Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the Transmission – Tx interface of the
receiver module.
Transmission-1 CAT:
faces to a CPU interface of the master matrix switch.
Transmission-2 CAT:
faces to a CPU interface of the master matrix switch.
Red. Power: If necessary, connect the connection cable of the optional power pack to
this interface. Then connect a power cable to the power pack and a power outlet.
Main Power: Insert the supplied power cable and connect it to a power outlet.
Start-up
Turn on the master and the slave matrix switch as well as the transceiver and
receiver module of the NEO-FiberLink series.
6 · NEO-FiberLink-2
Transmission-1 CAT Transmission-2 CAT
to master / higher-level device
Use a CAT5 (or better) twisted pair cable to connect these inter-
Use a CAT5 (or better) twisted pair cable to connect these inter-
Red. Power