Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
The transmitter and receiver module can either be placed between the master and
the slave matrix switch (cascade level 1) or between the slave matrix switches of the
second cascade level.
ADVICE:
Basic information regarding the cascading of a matrix switch is given in
the chapter Installing the expansion unit of the matrix switches' installation manual.
Connecting the transmitter module
(NEO-FiberLink-2Tx)
Place the transmitter module close to the slave matrix switch.
Class 1 Laser Product
Transmission Fiber
Transmission-1 CAT
Tx
Rx
Transmission – Tx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the Transmission – Rx interface of the
receiver module.
Insert the LC plug of the fibre optics, which is available as acces-
Transmission – Rx:
sory. Connect the other end of the cable to the Transmission – Tx interface of the
receiver module.
Transmission-1 CAT:
Use a CAT5 (or better) twisted pair cable to connect these inter-
faces to one of the CON interfaces of the slave matrix switch.
Transmission-2 CAT:
Use a CAT5 (or better) twisted pair cable to connect these inter-
faces to one of the CON interfaces of the slave matrix switch.
Red. Power:
If necessary, connect the connection cable of the optional power pack to
this interface. Then connect a power cable to the power pack and a power outlet.
Main Power:
Insert the supplied power cable and connect it to a power outlet.
Transmission-2 CAT
to slave / lower-level device
Installation
Red. Power
NEO-FiberLink-2 · 5
Werbung
Kapitel
Inhaltsverzeichnis
