Introduction; Package Contents - G&D NEO-FiberLink-2 Installationsanleitung

Introduction

The transmitter and the receiver module of the NEO-FiberLink series increase the
range between two matrix switches (CATCenter NEO) within a matrix system to up
to 10,000 metres. The data between the two modules is transmitted via two single-
mode fibre optics.
For each NEO-FiberLink system two CPU ports of the master matrix switch are con-
nected to two CON ports of the slave matrix switch. Now two users can simultane-
ously access the computers connected to the slave matrix switch.
Both transmitter and receiver module can either be placed between the master and
the slave matrix switch (cascade level 1) or between the slave matrix switches of the
second cascade level.
The figure on the right-hand side shows how to place the transmitter and receiver
module of the NEO-FiberLink series between two matrix switches.

Package contents

 1 × transmitter module (NEO-FiberLink-2Tx)
 1 × receiver module (NEO-FiberLink-2Rx)
 2 × power cable (PowerCable-2 Standard)
 1 × service cable (USB-Service-2)
 1 × manual
NOTE: The package contents of device variants for rack mounting also contain a
rack mount set.
Introduction
NEO-FiberLink-2 · 3