perrot P2S Bedienungsanleitung Seite 15

5.2 Setting the part circle angle
Infinitely variable by pulling (not pressing) the relevant end of the upper or lower
spring stop. The irrigated part circle has to be adjusted by the spring stops (see
sketch).
Setting part circle angle
ATTENTION
5.3 Full circle irrigation
For full circle irrigation the spring stops have to be removed.
ATTENTION
TDP057d+e.doc
Perrot REGNERBAU CALW GmbH
Infinitely variable by pulling (not pressing) the relevant end of the
upper or lower spring stop.
Only pull spring stops so far that you can slip them easily.
In case of overstretching them, they can't be used again for
part circle operation.
Rev. 22.10.2010
Industriestraße 19-29 / D-75382 Althengstett / Germany
Telefon : 0049-7051-162-0 / Fax : 0049-7051-162–133
E-mail :perrot@perrot.de / E-mail Konstruktion : technik@perrot.de
spring stop
Adjust here
spring stop
picture 3
Seite / Page 15 / 20