Steba CH 1 ECO Gebrauchsanweisung Seite 10

hen in operation.
ot in use.
or the power cord is damaged in any
∙ If the cordset is damaged and you have to change it, do not do
the job yourselves! Take the product to an after sales authorised
repair centre or to a person with similar skill and knowledge, in
order to avoid any risk of danger.
ate surroundings of a bath, shower
∙ Do not use this appliance close to showers, baths, swimming
pools.
ys make sure that the controls are in
∙ The appliance must be positioned so that the plug is always
plug by the cord. accessible.
∙ Do not use the appliance if the carbon heating element is frac-
ter the heater as this may cause an
tured.
please ensure that the heater is not
Installation of base plate
Put the oval base plate on the heating
and clip the cable into the slots.
etrol, paint or any other flammable
Attach the two pieces with the two
screws.
her than its intended purpose.
Safe positioning
d directly underneath a fixed power
∙ The device is not equipped with a thermostat that moni-
tors the room temperature. Do not use the device in small
spaces when there are people in the room who are not able to
oled fully before storing.
leave the room independently, unless constant supervision is
d be kept away unless continuously
provided.
∙ The appliance must be used only on a flat, stable surface.
∙ The appliance must be not accessible for persons who are ta-
king a bath or in the shower.
∙ Do not place the cable under a carpet.
∙ Mind that during function the cordset must be always com-
pletely pulled out.
10
CAUTION – Some parts of this product can
burns. Particular attention has to be given w
people are present.
Assembly:
Assemble the body frame and the base pla
sequences.
1. Take out the nuts and base from the packag
2. Insert the power cord through the slot pla
base and then assemble the body frame to the
3. Secure the body frame to the base plat
previously taken out. Insert the power cord
then fix it by the clamp.
Operation:
1. Place the heater on a firm level surface
least 3 feet away from any wall or combustib
2. Turn knob to 'I' for 500watt, 'II' for 1000
3. Down the knob " " fully on the heater to