AERA Superior Bedienungsanleitung Seite 32

MENU SySTEM
Band
• By pressing G / H select Band.
• By pressing F / E button, you can change the
channel type to C or S.
Channel
• By pressing G / H select Channel.
• Use F / E buttons to change the channel number.
You can also enter a number via digit buttons on the
remote control.
Standard
• By pressing G / H select Standard.
• Use F / E button to change the standard to B/G,
D/K, I or L/L'.
Colour System
• By pressing G / H select Colour System.
• Use F / E button to change the colour system to
PAL, SECAM or AUTO.
Search
• By pressing G / H select Search.
• Press F / E button to start search. The search will
stop when a signal is found.
NOTE: If you press the buttons with one-step moves, a
frequency of 0.25 Mhz will be advanced. However if
you press the buttons all at once, it will advance
automatically. To stop searching at a certain time, you
may press F / E buttons.
vCR Mode
• By pressing G / H select VCR mode.
• Use F / E buttons to set VCR Mode on or off.
HINT: If you want to watch a DVD , then you have to
set this item as "OFF".
Decoder
You can use this mode to connect any decoder to your
TV.
• By pressing G / H select Decoder
• Press the F / E buttons to turn it ON or OFF.
When you switch the Decoder setting to OFF, EXT1 output
will be muted. In this case, EXT1 output will not be avail-
able to display video. If it is switched ON, the EXT-1 out-
put will be the selected video source. Any decoder can be
connected to EXT1 to unscramble required video signal.
HINT: Decoder setting should be stored separately for
each programme.
Store
• By pressing G / H button select Store.
• Press E or "OK" button to store the adjustments.
"STORED" will be displayed on the screen.
A.P.S.
• By pressing G / H button select A.P.S.
• Press E button to enter the A.P.S. menu. A.P.S.
menu appears on the screen.
A.P.S. (Auto Programming System)
Country
Press F / E button to select your country. If you want
to exit from A.P.S. function, press the "TV" button. For
going back, press "MENU".
When you press OK button for starting APS, all stored
programs will be erased and the following screen will
be displayed.
Whenever you press the "TV" button, A.P.S. function
stops and Channel table appears on the screen.
If you wait until the end of A.P.S., Channel table is
displayed with the programmes found and located.
Teletext Region
• By pressing G / H button select Teletext Region.
2