Location Of Controls - Sony NV-U92T Anleitung

On the positioning system
The system has a function that allows the car's
current position to be correctly displayed even at
locations where the GPS signal is temporarily
interrupted or poorly received, as when going
under an overpass. To activate this function, do
the following.
– Attach the unit to the cradle.
– Drive for a while in an area where the GPS
signal is clearly received.
The positioning system will become ready for
operation after you have driven a little with the
unit on.
Notes
• The accuracy of this function may deteriorate if the
unit is installed near a heated or heat-reflecting
windscreen.
• Depending on the conditions, the car's current
position or the movement may not be accurately
displayed. This, however, will be corrected as soon
as the GPS signal reception resumes.
• This function is available only during route guidance.
On the software
Read the "END-USER LICENSE AGREEMENT"
carefully before use.

Location of controls

Refer to the pages listed for details.
a ?/1 (on/standby) button 6
To turn the unit on/off.
b Screen buttons 9
c Display window/touch screen
d Auto dimmer sensor
Detects ambient light and automatically
adjusts the display brightness.
e CHG (battery charge) indicator
Lights up in red while charging, and changes
to green when fully charged.
When the adapter is disconnected, the
indicator goes off.
f Cradle connector
g RESET button 15
h DC IN 5V jack
To connect to the car battery adapter or AC
adapter*.
i USB jack 11
To connect to a computer with the USB
cable.
j OPEN/RELEASE button
To open the built-in GPS aerial or remove the
unit from the cradle.
For details, see the supplied "Read This
First" (Installation Manual).
k Nameplate
l Built-in GPS aerial
m Speaker
Outputs guidance and warnings.
n Memory Stick access indicator
o Memory Stick Duo slot
For "Memory Stick Duo" insertion for
functional expansion.
p Headphone jack
This jack cannot be used as an audio output
terminal.
* Optional accessory
5