Resetting The Unit - Sony NV-U92T Anleitung

GPS signal cannot be received.
Firstly, read the GPS overview (page 4), then check the
GPS status by selecting "More..." in the top menu c
"GPS Status."
• The system cannot receive GPS signals due to an
obstruction.
t Move your car to a place where signals can be
received clearly.
• There is an obstacle in front of the GPS aerial.
t Install the unit where the signal is not interrupted
by the body of the car, etc.
The car position on the map does not match
the current road.
The error margin of the signal from the GPS satellites
is too large. A maximum error margin of a few
hundred metres can exist.
Voice guidance cannot be heard.
The volume is set too low.
t Raise the volume (page 9).
The LCD is not displayed normally.
• In high temperatures, the LCD may darken and not
display clearly. In low temperatures, afterimage may
occur on the LCD. These are not malfunctions, and
the LCD will return to normal when the temperature
returns to within the specified operating range.
• The LCD is dark.
t The auto dimmer function may be activated
because its sensor 4 (page 5) is covered by a
hand, etc.
The cradle comes off the attachment surface.
Attachment strength weakens if the surface of the
suction cup or attachment surface becomes dirty.
t Clean the surface of the suction cup and the
attachment surface with a soft, wet lint-free cloth
(page 12).
The demonstration mode starts automatically
even if no operation is performed.
t Turn off the auto demonstration mode by selecting
"More..." in the top menu c "Settings" c "General
Settings" c "Demo Mode." Then, confirm that
"Demo Mode" is set to off.

Resetting the unit

If the navigation software freezes, try resetting
the unit.
Press the RESET button, then press ?/1 to turn
on the unit.
Note
After you reset the unit, it may take time to receive
GPS signals when turning on the unit.
15