Flash Power Control - Vela 1500S Bedienungsanleitung

7, 7a, 7b:
Power control
switches
6:
LED display
HENSEL Studiotechnik

Flash power control

VELA S: The flash power can be set in 1/10 f-stop increments
using the power control switch 7 (5 f-stops).
VELA AS: The flash power can be set in 1/10 f-stop increments
using power control switches 7a and 7b. This covers a range of
6.5 f-stops. The output levels of all connected channels are
proportionally increased and reduced by pressing the up and
down control buttons.
The flash output will be shown on the two digits 7-segment
display 6 (see table below).
VELA AS: Flash power settings and LED display
Channel A (1 or 2 Heads, symmetrical):
Flash Power Output
47 J – 1500 J
Channel B (1 Head):
Flash Power Output
31 J – 500 J
31 J – 250 J
31 J – 125 J
Channel A1 + A2 + B „Max. 500J" (3 Heads, symmetrical):
Flash Power Output
1000 J (A) + 500 J (B)
..............
63 J (A) + 31 J (B)
Channel A1 or A2 + B „Max. 500J" (2 Heads, asymmetrical):
Flash Power Output
1000 J (A) + 500 J (B)
..............
63 J (A) + 31 J (B)
A1 and/or A2 + B „Max. 250J" (2 or 3 Heads, asymmetrical):
Flash Power Output
1000 J (A) + 250 J (B)
..............
125 J (A) + 31 J (B)
A1 and/or A2 + B „Max. 125J" (2 or 3 Heads, asymmetrical):
Flash Power Output
1000 J (A) + 125 J (B)
..............
250 J (A) + 31 J (B)
User Manual VELA S and AS Power Pack
LED Display
5 – 10
LED Display
4.4 – 8.4
4.4 – 7.4
4.4 – 6.4
LED Display
10.0
.....
6.0
LED Display
10.0
.....
6.0
LED Display
9.7
.....
6.7
LED Display
9.6
.....
7.6
35