Lamp Connections - Vela 1500S Bedienungsanleitung

10 Af
HENSEL Studiotechnik
Fuse for modeling lamp
The fuse is a general lamp fuse. Make sure that only fuses with
the required value 10 A-quick are used.
Fuse for halogen lamp in flash head
The halogen lamp
5 x 20 mm melting fuse.
Caution:
Make sure that depending on the mains voltage the right
modeling lamp is in use and protected by the specified type of
fuse (see table below):
300W Halogen lamp
650W Halogen lamp
Spare fuses for the power pack
Spare fuses are integrated in the grip rod of the bracket.

Lamp connections

Caution:
Before connecting lamp heads to the VELA AS power pack
check the mains voltage and make sure that the head is
allowed to be operated (115V
power packs are for 230V operation only.
For flash head connection the heads of the EHT and MH line
with at least 3000 J are available as well as the EHT 3000 E
flash head.
Before starting up the maximum loading of the flash head must
be observed (minimum 3000 Ws).
The admissible load capacity of a flash head will be controlled
by a flash head plug-code. In case of connecting an
inadmissible flash head to the power pack, the code will block
flash release. Only flash head extension cables with the plug-
code must be used. The cables can be ordered with precise
specification from HENSEL Studiotechnik.
Lamp heads / flash heads with halogen lamps, which are not
equipped with a cooling fan, must not be used. During quick
flash sequences, the flashtubes and therefore also the power
pack would be damaged.
User Manual VELA S and AS Power Pack
in the head is
Ue = 230 V
1,6 Af quick
3,15 Af quick
∼ ∼
/ 230V / Bi-Voltage). VELA S
protected by a
Ue = 115 V*
3,15 Af quick
-----
31