Acclimatizing; Positioning; Mains Connection; Fuses - Vela 1500S Bedienungsanleitung

User Manual VELA S and AS Power Pack
30
Heating
Due to the modeling and flashlight, each power pack and flash
head emits heat. This can heat up the parts of the unit to a
dangerous level. Therefore make sure, that power packs and
lamp heads are located far enough from inflammable props to
avoid inflaming them. Take care for sufficient air supply and
make sure that ventilation slots of power packs and flash
heads are kept free.
Do not operate power packs and flash heads unattended.
Due to the danger of overheating, the modeling light should
never be operated at full power for more than 20 minutes.
Then adequate cooling should be provided for. The modeling
light should never be used for lighting up the studio but only as
an assistance when focusing or determining the light guiding
and shadow details of the flash.

Acclimatizing

When moving power pack from one climatic zone to the next,
the appliance should stand in the room, in which it will be
operated, for some time before starting it up. This prevents
internal shortcuts, which might occur by condensing water.

Positioning

VELA power packs can be operated standing up.

Mains connection

The type label can be found on the bottom of the appliance.
Multivoltage Version
The VELA AS power pack adjusts itself for different main
voltages. VELA S power pack is for 230V operation only.
Flash power packs must only be connected to mains
outlets with ground connection.
Insert the plug of the provided power cable into the mains
connector (laterally) and then connect the cable to the mains
outlet.

Fuses

Outlets, in the building
Ue = 230 V: 16 A
Ue = 115 V*: 20 A
HENSEL Studiotechnik