First Steps; Power Connection; Inserting The Batteries (Optional); General Operations - Albrecht DR 65 C Bedienungsanleitung

3. First Steps

3.1. Power connection

1. Connect the power supply into the socket on the back of the radio and fully extend the tel-
escopic aerial in a vertical position to obtain the maximum signal strength.
2. Plug the power adaptor into the mains power wall socket.
3. Slide the On/Off power switch on the back of the radio. The display will light up and show the
Albrecht starting screen. Your radio will then go to Standby mode. Start the radio by pressing
the Standby button. The radio will automatically enter DAB mode and start a full scanNOTE:
When using batteries the standby mode is disabled. Thus the radio will immediately start scan-
ning for DAB stations.
4. When the scan is complete your radio will select the first available station and begin to play.
Stations are listed in numerical and then alphabetical order by default.

3.2. Inserting the batteries (optional)

1. Before installing the batteries (not included) please ensure that the radio is switched off (slide
the power switch on the back to Off) and is unplugged from the mains power supply.
2. On the back of the radio, push in the tab to release and remove the battery compartment cover.
3. Insert 4 x 1.5V AA-size (also known as LR6) batteries, making sure to use them with correct
polarity as shown in the compartment.
4. Close the battery cover, making sure it 'clicks' shut.

4. General Operations

4.1. Adjusting the Volume

• Turn clockwise to increase the volume.
• Turn anti-clockwise to decrease the volume.

4.2. Menu Navigation

• Scroll through the menus by using the rotary knob.
• Confirm a selection by pressing OK.
• Leave a menu by pressing Back

4.3. Change the Mode

Press and release the Mode button to change between DAB and FM mode.
22 English