Installation Location - inqua BR021000 Gebrauchsanweisung

Installation
location
®
The INQUA Inhalator is designed exclusively for indoor use, it is
not intended to be used outdoors.
Follow these instructions regarding the installation location:
CAUTION: Risk of damage to the compressor due to overheat-
ing and dust
The compressor is fitted with a fan to ensure that the motor is cooled
constantly. If the fan is not able to cool the motor sufficiently, the
motor may overheat and be damaged.

Only operate the compressor in locations with low dust contami-
nation and an adequate air supply. The ventilation slits of the
compressor must never be obstructed.

Never cover the compressor while it is in use.

Do not run the compressor on carpets or in very dusty environ-
ments, e.g. under the bed, in workshops etc.

Observe the ambient conditions specified in
section "Environmental conditions for operation", page 39.

Do not operate the compressor in explosion-prone areas or in the
presence of oxidising gases (e.g. oxygen, nitrous oxide, flamma-
ble anaesthetics), or in damp locations.

Protect the power cord from excessive heat and oil.

Do not operate the compressor close to flammable objects such
as curtains, tablecloths, or paper.

Keep the compressor and the power cord away from hot surfaces
(e.g., cookers, radiators, open fires). These might damage the
compressor housing or the power cord insulation.

Keep the power cord away from household pets (e.g. rodents).
Animals may damage the insulation on the power cord.

Plug the compressor into an easily accessible mains socket so
that it can be disconnected from the power source quickly.

Route the power cord in such a way that it does not present a trip-
ping hazard and people cannot become entangled in it.

Make sure that children are not able to pull the compressor down
by the power cord or connection tubing.
en
37