Automatic Heat Up - AEG HC 452021EB Benutzerinformation

To activate the outer ring: touch the
sensor field. The indicator comes on.
To activate more outer rings: touch the
same sensor field again. The subsequent
indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.
When you activate the zone
but do not activate the outer
ring the light that comes out
from the zone may cover the
outer ring. It does not mean
that the outer ring is
activated. To see if the ring
is activated check the
indicator.

4.5 Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch ( comes on).
Immediately touch the correct heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.
4.6 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function.The selection of the Timer
function is possible for cooking zones
that are active and after the heat setting
is set.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on. When
this function is active,
comes on.
comes on.
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
cooking zone starts to flash slowly the
time counts down.
To see the remaining time: set the
cooking zone with
the cooking zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the cooking
zone with . Touch
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking
zone deactivates.
To stop the sound: touch
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the cooking zone operates.
To set the cooking zone (if more than
1 cooking zone operates): touch
again and again until the indicator of a
necessary cooking zone comes on. When
this function is active,
To activate the function: touch
symbol goes out and
To see how long the cooking zone
operates: set the cooking zone with
The indicator of the cooking zone starts
to flash quickly. The display shows how
long the zone operates. During the first
minute the display shows the time in
seconds. After the first minute the
display shows the time in minutes.
To deactivate the function: set the
cooking zone with
. The symbol goes out and
comes on.
ENGLISH 9
of
. The indicator of
or .
and touch . The
.
comes on.
. The
comes on.
.
and touch or