Adding A Timer; Editing A Timer; Deleting A Timer; Configuring Date/Time Settings - Schaub Lorenz 32LT400 Bedienungsanleitung

Press " " button to set timers on an event. Programme
timer function buttons will be displayed on the
screen.

Adding a Timer

• Press YELLOW button on the remote control to
add a timer. The following menu appears on the
screen:
Channel: Changes network type by using " " or " ".
Timer Type: This feature is unavailable to be set.
Date: Enter a date using the numeric buttons.
Start: Enter a starting time using the numeric
buttons.
End: Enter an ending time using the numeric
buttons.
Duration: Displays duration between the starting and
ending time.
Repeat: Sets a timer to be repeated as Once, Daily or
Weekly. Use " " or " " buttons to select an option.
• Press GREEN button to save the timer. Press RED
button to cancel.
Change/Delete:Controls parental settings on timers.

Editing a Timer

• Select the timer you want to edit by pressing "
or " " button.
• Press GREEN button. Edit Timer menu screen will
be displayed.
• When finished with editing, press
save. You can press "MENU" button to cancel.

Deleting a Timer

• Select the timer you want to delete by pressing "
" or " " button.
• Press RED button.
• Select YES by using " " or " " buttons to delete the
timer. Select NO to cancel.
Configuring Date/Time Settings
Select Date/Time in the Settings menu to configure
Date/Time settings. Press OK button.
•
Date,Time,Time Settings Mode and Time Zone Setting
will be available.
Use " " or " " buttons to highlight the Time Settings
Mode. Time Settings Mode is set using " " or " "
buttons. It can be set to AUTO or MANUAL.
When AUTO is selected, Date/Time and Time Zone
options will not be available to be set. If MANUAL
option is selected as the Time Zone can be altered:
• By pressing " " or " " buttons select Time Zone.
Use " " or " " buttons to change the Time Zone
between GMT-12 or GMT+12. Date/Time on the top
of the menu list will then change according to the
selected Time Zone.
•
You can enables or disable selected source options. The
TV will not switch to the disabled source options when
"SOURCE" button is pressed.
"
GREEN button to
•
•
•
Note : YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).
English - 65 -
Use " " or " " buttons to highlight Date/Time.
Changes are automatically stored. Press
to exit.
Configuring Source Settings
Sources in the Settings menu and press OK
Select
button.
Press" " or " " buttons to select a source.
Use " " or " " button to enable or disable the
selected source. Changes are automatically
stored.
"MENU"